To maximize humidity circulation, put your unit near a cold air return. Make sure it’s at least two inches from the wall so the humidistat (on the cord) can accurately read your humidity It should be on a level surface against an interior wall. Put your Space Saver in the most centrally-located room of your home. The fan switch looks like a small, silver diving board. Make sure the top of the float rod makes a solid connection with the fan switch inside the fan assembly. Secure the rod to the humidifier with the float retainer, as shown. Place the float (with the float rod as pictured) in the square area in the bottom of the cabinet. Remove the tape from your wick frame and place the wick and wick frame in the cabinet with the side labeled FRONT facing the front, curved side of the unit Locate the PLACE WICK HERE label inside your Space Saver cabinet. Just use your hands! Using tools can crack the cabinet. Turn the cabinet over and insert the casters snugly into the bottom. Do not throw away the small Styrofoam cube – this is your float. Remove the Space Saver from its packaging. If your unit has a digital conrol panel with buttons, you have the Space Saver 831000. To reduce the risk of fire, do not use near an open flame such as a candle or other flame source.To reduce the risk of accidental electrical shock, do not touch the cord or controls with wet hands.To reduce the risk of electrical hazard or damage to humidifier, do not tilt, jolt or tip humidifier while unit is running.Close attention is necessary when used by or near children. Do not allow unit to be used as a toy.Do not put foreign objects inside the humidifier.Never use flammable, combustible or poisonous materials to clean your humidifier To reduce the risk of injury, fire or damage to humidifier, use only cleaners specifically recommended for humidifiers. Always unplug the unit before moving, cleaning or removing the fan assembly section from the humidifier, or whenever it is not in service.To reduce the risk of fire hazard, never put the electric cord under rugs, near heat registers, radiators, stoves or heaters. Keep the electric cord out of traffic areas.If it still does not fit, contact a qualified electrician to install the proper outlet. If the plug does not fully fit into the outlet, reverse plug. Plug humidifier directly into a 120V, A.C. To reduce the risk of fire or shock hazard, this humidifier has a polarized plug (one blade is wider than the other).Contact us for replacement parts at 800.547.3888. Do not use the humidifier if any parts are damaged or missing. If these get wet, let them dry completely and have unit checked by authorized service personnel before plugging in. Do not pour or spill water onto the controls or motor area. To reduce the risk of fire, electric shock, or injury, always unplug the unit before moving, filling, servicing, or cleaning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |